Zip 303061, Инструкция по установке и эксплуатации

Страница: 6 / 24

Page 6 of 24
804546 03.17 1.00
long, has no more than 3 right angle bends, and visibly discharges to a
waste water drain.
For concealed vent plumbing, connect plumbing to the vent outlet from the
heater rear using a elbow protruding 45 mm from the wall.
Alternatively attach a tun dish to the wall as shown and plumb away to
waste.
Note: when routing the plumbing for the vent / tundish installed and
mains inlet line, ensure you do not obstruct filter access for filter
replacement.
3.3 Electrical
For an exposed electrical connection, the pre-fitted flex and plug cable
is plugged into the PCB as shown. Use a standard GPO power outlet
within 1500 mm from the heater with adequate power for the unit.
For a concealed electrical connection, disconnect the pre-fitted
flex and plug cable at the PCB connector and discard. Connect the
concealed power cable through the rear access opening to the green
terminal block on the PCB.
Check that the earth is connected through the PCB to the chassis with
an ohm meter.
Warning: Do not connect both options. It is essential that the flex and
plug cable is removed from the PCB if the concealed connection is
used. Otherwise the GPO plug will become live.
Step 4 – Installing Filter Guide
Assemble the fi lter guide provided with the unit, make sure it is locked in position, then put the cover back on.
1. Push the fi lter guide upwards
2. Rotate anti-clockwise until locked
Step 4 – Installing Filter Guide
Installation Procedures