Remove your mattress, bedding, and any other objects from
the upper bunk of your bed.
2
Prior to installing the kit, inspect the welds for cracks at the
four locations where the horizontal side rails of the upper
bunk are connected to the vertical bars of the guardrail.
1
3
Use the Allen wrench (E) to remove the upper bolt that
attaches the guardrail to one of the four bed posts.
4
Position the washer of a cable (A) at the bolt hole of the
guardrail, and reinsert the bolt you removed in Step 3
through the washer and tighten it, using the Allen wrench (E).
5
On the same bed post, position a bracket (B) directly below
the horizontal side rail of the upper bed frame. Slide the
bracket inward from the outside of the bedpost.
A
B
6
Position the threaded nut block (C) on the opposite side of
the bracket (B). Align the threading of the nut block with the
holes in the bracket (B).
C
7
Position the washer of the unattached end of the cable (A),
which was secured in step 4, at the bolt hole on the outside
of the bracket (B), as shown in the graphic at the top of the
next column.
8
Insert a bolt (D) through the washer and bracket (B) and into
the threaded nut block (C), and tighten the bolt, using the
Allen wrench (E).
D
D
9
Insert another bolt (D) through the opposite side of the
bracket (B) and into the threaded nut block (C) (from the
inside of the bed) and tighten the bolt, using the Allen
wrench (E).
F
F
10
To prevent any openings where little fingers could get stuck
between the cable (A) and the bed post, wrap one zip tie (F)
around the top of the cable, bed post, and vertical bar of the
guardrail and tighten the zip tie (F) so as to pull the cable (A)
in towards the bed post, then wrap another zip tie (F) just
like the first zip tie around the bottom of the cable (A).
11
Repeat steps 3-10 for each of the remaining three bed posts.
