3
Manual Reset
Automatic Reset
Normally
Closed
Ground
Normally
Open
Normally
Closed
Ground
Normally
Open
Common
Common
Single Pole Double Throw
15A—125, 250 or 480 VAC
1/4 HP—125 VAC, 1/2 HP– 250 VAC
1/2A—125 VDC, 1/4A—250 VDC
Single Pole Double Throw
15A—125, 250 or 480 VAC, 2A—600 VAC
1/8 HP—125 VAC, 1/4 HP—250 VAC
1/2A—125VDC, 1/4A—250 VDC
Notes Regarding Wiring
Ensure wire insulation is not damaged
Connect Wires Firmly to micro switch terminals
(torque to 4 inch lbs.)
Wiring must meet or exceed circuitry requirements
3.1
Use 3/16“ hex key to loosen the Enclosure
Cover/Security feature.
3.2
Use a spanner wrench (1/4” pin, 2-4 3/4”
span) to break loose the
Enclosure
Cover and
Complete removal by hand.
3.3
Connect wires to micro switch as required.
3.4
Thread 1/2” MNPT electrical cord Union into
the Electrical Port located on the side of the
electrical enclosure housing, 5+ Turns
3.5
Thread
Enclosure Cover
back onto the
Electrical Enclosure and ensure it is properly
seated prior to applying electricity.
3
Wiring
Electrical
Enclosure
Cover
3/16” cap screw
locks cover in place
and fastens car seal
locking feature
1/2”FNPT
Electrical
Conduit Port
Figure 2
Figure 3
Figure 4
ZIMCO INSTRUMENTATION INC.
11141 15 Street NE, Calgary, AB, T3K 0Z5, Canada
Phone:
403-253-8320
Email:
Website:
www.zimco.ca
