Z183 EMAC Board
User Manual
5
UM008301-0401
9. In the Hyperterminal application, pull down the CALL menu and select Call
(Windows 98) or Connect (Windows NT). The Hyperterminal window
displays the following information, which indicates that the Z183 board is
working properly.
10. Press the RESET button on the Z183 board to display the text message in
the window shown above. If the text does not appear, repeat the
configuration process.
Installing the EMAC Board
To install the EMAC board, follow these steps:
1. Unpack the EMAC board and the interrupt cable.
2. Hold the EMAC board so that the components are facing upward.
3. Make sure the Z183 board is turned off.
4. Place the EMAC board’s 50-pin J1 socket header directly over the J22 pin
header of the Z183 board. The EMAC board has support studs that allow it
to rest on the desk surface.
5. Press the EMAC board down firmly onto the Z183 board. You may need to
bend the connectors of the red power LED to get the connectors to mate
properly.
6. Use a jumper cable to connect JP3 on the EMAC board to INT1 on the Z183
board. The interrupt cable has a 6-pin socket header that should be plugged
into JP3 on the EMAC board. The other end of the cable is a 10-pin socket
header that must be plugged into J23 on the Z183 board near the RESET
ZiLOG Z80183 Monitor Version 2.8
Z80183
