Zigen ZIG-PHASED, Руководство пользователя

Страница: 10 / 19

10 of 19
ZIG-PHASED 1x2 Repeater User Manual
UM-001-0001-000-01 | March 12, 2021 © 2021 Zigen Corporation
www.zigencorp.com
Z
IG
-P
HA
S
E
D
Us
er Ma
nu
a
l
default mode, Auto, press and hold the HDR pushbutton for approximately 2 seconds until the Video
LEDs illuminate 0011 and all other LEDs in the front panel are off. The HDCP Management setting will
be memorized and recalled during a power cycle.
ARC CEC Settings
The ARC CEC Settings can be set to “ AUTO ” or “ OFF ” depending on the installation. If the Phased is used
to extract ARC from a SmartTV and there is no ARC featured AVR connected on its HDMI Input (refer to
Figure 2: ZIG-PHASED 1:2 Repeater. Audio extracted from HDMI In or ARC from SmartTV. ), then
configure ARC CEC to “ Auto ” to allow the Phased to negotiate with the SmartTV to output its ARC audio.
In this interconnect, the Phased becomes the “ Audio System ” .
If the Phased is used in conjunction with an ARC featured AVR at the input (refer to
Figure 3: ARC Passive
Mode with an ARC Enabled Audio/Video Receiver. ), then configure ARC CEC to “Off” to allow the AVR
to negotiate with the SmartTV to output its ARC audio. In this interconnect, the AVR becomes the “ Audio
System ” .
To configure ARC CEC Settings to
“ Off ” , press and hold the Audio pushbutton for approximately 2
seconds until the ARC Source LEDs illuminate 10 and all other LEDs in the front panel are off. To configure
ARC CEC Settings to
“ Auto ” , press and hold the Audio pushbutton for approximately 2 seconds until the
ARC Source LEDs illuminate 11 and all other LEDs in the front panel are off. Once the desired ARC CEC
Settings are configured, power cycle the Phased to apply the new settings.
Important: If the ARC CEC Settings is changed, power cycle the Phased so the new settings
will take effect.
Locking and Unlocking the Pushbuttons
Once the ZIG-PHASED pushbutton modes have been set, the pushbuttons can be locked to prevent
accidental presses and inadvertent changes to the uni
t’s operation. To lock the pushbuttons, press and
hold both VIDEO and AUDIO SRC at the same time until the front panel LEDs change illumination to all
off. The front panel pushbuttons are now locked and the operational modes cannot be changed.
To unlock the pushbuttons, press and hold both VIDEO and AUDIO SRC at the same time until the front
panel LEDs change illumination to all off
. The unit’s operational modes can now be changed using the
pushbuttons.
Front Panel