TR1200
12320-0702-03
Seite
10 / 20
www.ziehl.de
8.8 Configuring the relay
Adjustment process:
Select the menu item with the Up/Down key until …
Display
8
rel.
8
(Relay function)
Press the Set key
Display
8
rel
8
/
8
r
8
(Relay function / Zero signal current) flash alternately
Use the Up and Down keys to select the relay function
Press the Set key (exits the configuration mode)
Display
8
rel.
8
(Relay function)
8.9 Configuring the RS485 interface
Adjustment process:
Select the menu item with the Up/Down key until …
Display
8
bus.
8
(Bus)
Press the Set key
Display
8
prt
8
/
8
485
8
(Protocol / 485) flash alternately
Set the desired protocol using the Up and Down keys
Press the Set key
Display
8
adr
8
/
8
0
8
(Device address / Value) flash alternately
Set the desired device address using the Up and Down keys
Press the Set key
Display
8
bdr
8
/
8
96
8
(Baud rate / Value) flash alternately
Set the desired baud rate using the Up and Down keys
Press the Set key
Display
8
par
8
/
8
eve
8
(Parity / Value) flash alternately
Set the desired parity bit using the Up and Down keys
Press the Set key (exits the configuration mode)
Display
8
bus.
8
(Bus)
Note:
The set device address always applies
for the transmission of Sensors 1…6.
If at least one of the sensors 7…12 as is configured as 2- or 3-conductor
(not „nc“), they will be transmitted with the set device 1.
More information about Modbus configuration and programming can be found in
Appendix 1 (Download from
www.ziehl.com
)
