4 Mounting the module
4.1 Safety precautions
Danger due to electric current
•
Always read the safety instructions chapter before mounting!
•
Work on electric components may only be carried out by trained electricians or by
persons instructed in electricity under the supervision of an electrician in accordance
with electrical engineering regulations.
•
It is forbidden to carry out work on electrically live parts.
•
The terminating device (fan, converter) in which the module is to be installed must
be disconnected from the line voltage for at least 3 minutes before opening!
Attention, electrostatic sensitive devices!
•
Damage to electronic components by electrostatic charging must be prevented!
•
Touch the protective earth connection in the terminal to equalize the potential
immediately before removing the module from the packing. This applies regardless
of whether the device is already connected to the line.
•
Equalize the potential again shortly before installation if the module is not installed
immediately after unpacking.
•
After unpacking the module, check for possible transport damage and insert it in the
slot provided. Do not touch the connection!
4.2 Procedure
Proceed as follows:
"
Press the module as far as possible into the holder to the correct position and check
that it is
fi
tted securely.
"
When an AM-STICK-WB module is installed in a fan or converter from
ZIEHL-ABEGG, the enclosed label must be stuck to the housing of the terminating
device.
"FCC/IC" label for AM-STICK-WB
Made in Germany
AM-STICK-WB
Contains FCC ID:
Contains IC:
Contient IC:
T7V1740
216Q-1740
216Q-1740
Quick Start Guide
AM-STICK-WB
Mounting the module
L-BAL-E289-GB 1822 Index 003
Part.-No.
10/19
