Over DIP 4 an inverting of the input is possible for mode
1.01
speed controller.
•
DIP 4 =
|
OFF
|
(factory setting) for signals: 0 - 10 V, 2 - 10 V, 0 - 20 mA, 4 - 20 mA
•
DIP 4 =
|
ON
|
for signals: 10 - 0 V, 10 - 2 V, 20 - 0 mA, 20 - 4 mA
Attention!
Never apply line voltage to analog inputs!
5.7 Output voltage 10 V (A = Analog Out)
Constant v10 V e. g. for external potentiometer by operation as speed controller
1.01
. Connection to terminals
“
A1
”
-
“
GND
”
=
“
Analog Out 1
”
(I
max
10 mA).
Attention!
It is not permissible to connect outputs of several devices to each other!
5.8 Voltage supply for external devices (+24V, GND)
A voltage supply is integrated for external devices e.g. a sensor (max. current load see
technical data).
In case of overload or short circuit (24 V
–
GND), the external power supply is shut down
(multi-fuse). The device performs a
“
Reset
”
and continues operation.
•
It is not permissible to connect voltage outputs of several devices to each other!
•
It is not permissible to connect voltage outputs in the device to each other!
5.9 Enable, Device ON / OFF (Digital In 1 = D1)
Electronic disconnection via
fl
oating contact at terminals
“
D1
”
-
“
GND
”
•
Device
“
ON
”
for closed contact.
•
Controller
“
OFF
”
with opened contact. Internal signal lamp
fl
ashes in code
|
1
|
(
Diagnostics / Faults).
Activation via
fl
oating contacts, a low voltage of approx. 24 V DC is connected.
Attention!
No disconnection (isolation) when turned off, in accordance with VBG4
§
6)!
Never apply line voltage to the digital input!
It is not permissible to connect inputs of several devices to each other!
Operating Instructions
Acontrol
PDE-6 / PDE-10
Electrical installation
L-BAL-E048-GB 1921 Index 005
Part.-No.
14/29
