Zico QUIC-LIFT PTS-HA-24, Запчасти и инструкция по эксплуатации

Страница: 4 / 32

-4-
B. Mounting the System (continued)
Check for any obstructions behind or below the selected mounting locations. Also be sure you can
run your wiring unobstructed through the back of the base castings. The outboard ends of the devices
cannot be obstructed as access is necessary for mounting, emergency operation, and adjustment of the
actuators.
You are now ready to mount the devices as follows (refer to page 10 for item numbers in
parenthesis):
1. The flat surface, between the three ears on the base castings (1 or 2) should be flush and parallel
with the edge of the mounting surface. Both devices should be parallel and in-line to within 1/16"
of each other.
2. Pull cotterless pin (35) and lower the shelf casting (4 or 5).
3. Mark eight base holes and two lower back holes. Remove devices.
4. Drill ten holes for 3/8" mounting bolts (not supplied). Replace devices, insert bolts and snug up
on nuts.
5. Pull cotterless pin (34) and remove the shelf arm casting (3).
6. Lay hydraulic actuator (13) forward and also lay Back Arm Casting (6) forward.
7. Mark two top holes in base casting (if used). Also mark hole location for electrical wiring
through bottom rear of base casting.
8. Remove device and drill holes for the two top holes in base casting and for the wiring.
9. Re-position devices on shelf and mount in place with 3/8" bolts and nuts.
10. Wiring should be run through lower hole in base casting at this time. We suggest the wire be run
in a protective sheath to prevent chaffing. The wire should be run under the actuator adjuster casting
(7) and up to the wire harness.
11. Flip the back arm casting (6) and hydraulic actuator (13) back. Connect wires to actuator and
check clearance through full swing of actuator. Replace shelf arm casting (3) and pin the three units
together using cotterless pin (34). Flip up the shelf casting (4 or 5) and place cotterless pin (35)
through the shelf casting and shelf arm casting (3).