E
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted, when the heater is burning. Use the
adjustment keys
to adjust the temperature. First press either of the two keys to
switch on the function (the °C mark and 4-digit
will start blinking). Next, adjust
the temperature using the key (
쑿
min.) to set the temperature to a higher setting
and the key (
쑼
hour) to lower the temperature. Press once to increase the value
one step. After approximately 10 seconds the °C mark and 4-digit will stop
blinking and the setting will be locked (Fig. F).
The available temperature settings range from 6°C minimum to 28°C maximum.
When the heater has been unplugged for more than 10 minutes (or after a power
failure), the temperature will reset to the factory setting of 20°C.
F
USING THE TIMER
The timer allows you to switch on the heater automatically at a preset time.
In order to switch on the timer, the correct time must have been set (refer to
Section C) and the heater should be off. Follow the procedure below:
Press the
button
and then the TIMER key
immediately after that.
The TIMER light and the information display
will start blinking.
Use the adjustment keys
to set the time at which the heater must ignite.
Use the key (
쑼
hour) to set the hours and the key (
쑿
min.) to set the minutes
(interval of 5 minutes).
After approximately 10 seconds the information display will show CLOCK
again and the TIMER indicator light will light up, indicating that the timer
function has been activated (Fig. H).
The timer will ensure that the room will have been heated to approximately
the required temperature at the set time.
When you want to switch off the heater and ignite it again with the timer, all
you have to do is press the TIMER key (refer to Section G).
Press the
button
once to clear the timer setting.
G
SWITC HING OFF THE HEATER
There are two ways to switch off the heater.
Press the
button
. The information display will show the CLOCK
signal. Within approximately one minute the flame will have extinguished.
Press the TIMER key
, when you want to switch off the heater and ignite it
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function. You can change the required time with the
adjustment keys
(refer to Section F).
1
2
1
2
4
57
G: The required
temperature on the left,
the measured
temperature on the
right.
H: The TIMER indicator
light indicates that the
timer function has been
switched on.
+
