+
Check the removable tank fuel gauge
while filling the tank (Fig. E). Stop
filling by loosening the switch button on top of the pump (turn anti-clock-
wise), once the gauge indicates that the tank is full. Never overfill the tank,
especially not when the fuel is very cold (fuel expands when it heats up).
Let the remaining fuel in the pump flow back into the jerrycan and carefully
remove the pump. Carefully screw the fuel cap back on the tank using the
fuel cap cover. After use, re-store the cover at the rear of the heater. Clean
off any spilled fuel.
Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
C
SETTING THE CLOCK
It is only possible to set the correct time, when the heater is connected to the
mains and not burning. Use the adjustment keys
to set the time. First press
either of the two keys to switch on the function (the CLOCK light and the
information display
will start blinking). Next, set the hours using the key on the
left (
HOUR) and the minutes using the key on the right (
MIN). Press once to
increase the value by one step. When you hold down the key, the value will
continue going up, until you release the key again. After approximately 10
seconds the blinking will stop and the setting will be locked. 5 Minutes after
switching off the heater, the information on the display will disappear and the
heater will automatically switch into the stand-by position.
When the heater has been unplugged for more than 10 minutes (or after a
power failure), the time needs to be set again.
D
IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation.
Always ignite the heater with the
button
. Never use matches or a cigarette
lighter.Just press the
button
to ignite the heater. The button will start
blinking, indicating that the ignition procedure has started. This will take a short
while. Once the heater is burning, the
button will remain lit (red). The
information display
will show two numbers. The light next to them indicates
that these numbers refer to the temperatures (Fig. G). The actual room
temperature is indicated below ROOM, while the temperature setting is indicated
below SET. The latter can be changed with the adjustment keys
(refer to Section E).
Prior to igniting the heater, always check for sufficient fuel in the removable tank.
E
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted, when the heater is burning. Use the
adjustment keys
to adjust the temperature. First press either of the two keys to
switch on the function (the TEMP light next to the information display
will start
blinking). Next, adjust the temperature using the key on the right (
MIN) to set
the temperature to a higher setting and the key on the left (
HOUR) to lower the
temperature. Press once to increase the value one step. After approximately 10
seconds the light will stop blinking and the setting will be locked (Fig. G).
8
7
6
4
46
E
empty
full
G: The required
temperature on the left,
the measured
temperature on the
right.
SAVE
TIMER
2 0
SET
TEMP
CLOCK
F: When the CLOCK
indicator light stops
blinking, the setting has
been locked to the
indicated value.
AVE
TIMER
VENT
1 9 : 1 4
SET ROOM
TEMP
CLOCK
