Big pipe There-way pipe
◆
If the sample solution could potentially stain the prism, immediately clean the prism after measurement .
◆
Before running hazardous substance(s) through any precautions should be taken to ensure the safe handling of
the hazardous system, necessary substance(s). If using a sample inlet unit, use caution when disconnecting the
GND15 .
◆
Cleaning liquids up to 150
℃
can be used for CIP or SIP . The cleaning liquid can be used safely for 30 minutes
at one time. The momentary difference between the sample liquid temperature and the cleaning liquid temperature
must be no more than 80
℃
. When using cleaning liquids at temperatures over 150
℃
, the power source (DC24V)
must be turned off.
◆
Detach the clamp band that connects the main unit to the sample inlet unit, piping or tank.
◆
Clean the prism surface carefully with a soft tissue soaked with warm water or ethyl alcohol. If the sample
solution contains oil or grease, use ethyl alcohol
to ensure the prism surface does not develop a film. Development of a film on the prism could cause erroneous
measurements.
◆
NEVER clean the prism with an abrasive material.
◆
Cleaning the prism with an abrasive material could cause scratches on the prism which could lead to erroneous
measurements.
◆
After cleaning is complete, re-attach the GND15 unit to the sample inlet unit, piping or tank. The procedure is
described on the instruction manual.
Note :we also can supply Auto or manual washing device for optional, if need , Please specify when
confirming the order
ZHYQ Sensor&Control Page 13 of 15
Cleaning the Prism
In-line Refractometer
Model : GND15
（
high temperature Application
）
