Zhone TNE1544, Руководство по установке

Страница: 16 / 26

16
Refer to your terminal emulation program’s user manual for further information.
Logging Into the CLI
Once your terminal emulation program has been launched, device information is
displayed, followed by a request for username and password. You must log in as a
superuser in order to make configuration changes.
Username: superuser
Password: Password
After you have logged in, enter a question mark (?) to list the available commands.
CLI Set commands are used to establish inband management. For example:
set slot 1 ip_address 137.182.10.251
set slot 1 subnet_mask 255.255.255.0
set slot 1 default_gateway 137.182.10.10
The Subscriber unit in this example can now be managed with web management by
attaching a PC to one of the network extender’s Ethernet ports and opening the
address 137.182.10.251 in a web browser.
Resetting the Network Extender to Factory Defaults
The network extender supports a reset process that may be used to delete the current
configuration and return it to the factory defaults, including the default password.
Procedure
To return the network extender to its factory default configuration:
1. The reset button is located behind a small hole on the left side of the faceplate of
the network extender. Use a straightened paper clip to gently push the button and
let it go.
2. Wait a few seconds until the T1 Port LEDs flash green starting at Port 1 and
ending at Port 4 or 5, depending on the TNE15x4 model that you have. Gently
push the reset button again during the time that the LEDs are flashing between
Ports 1 and 5. After the unit boots back up, NVRAM is cleared, and all
configurations on the unit are set to the factory defaults.