9126-A2-ZN11-40
27
Connecting the Modem
Procedure
1
Insert the RJ11C connector on the modem cable into the Modem/MDM interface.
2
Insert the other end of the cable into the phone service RJ11C jack.
3
Verify modem operation.
If Port Use is set to Terminal (dial-in access):
— Dial the modem’s phone number using a remote asynchronous terminal or PC.
— Verify that the Main Menu appears.
If Port Use is set to Net Link (SNMP, Telnet, FTP, and trap dial-out):
— Dial the modem’s phone number using a PC running PPP or SLIP link protocol.
— From the PC, run an IP Ping test to the modem interface.
If your results using either method are unsuccessful, make sure both ends of the modem
cable are properly seated and secured. Then, verify that the modem was configured
correctly (see
Setting Up the Modem
on page 18). Otherwise, refer to the status information
in the
iMarc SLV Operations Guide
.
Proceed to on
Connecting to the ISDN Interface
on page 28 if the iMarc unit is equipped with a
DBM.
POWER
COM
DBM
DSX-1
MDM
NET
DSX
ENET
02-17289
RJ11C
Jack
