9126-A2-ZN11-40
23
Connecting to the Network
Procedure
Now that the iMarc unit is set up, the unit can be connected to the network.
1
Insert the 8-pin connector of the RJ48C network cable into the network interface.
2
Insert the other end of the cable into the RJ48C modular jack.
NOTE:
After connecting the network cable, wait about a minute to allow Auto-Configuration a
chance to discover the operating rate and the DLCIs.
3
Verify that the Network signal (SIG) LED is green, and that the Network out-of-frame
(OOF) and alarm (ALM) LEDs are off. If so, the network interface is set up correctly and is
operational. If not, make sure both ends of the network cable are properly seated.
4
Check Health and Status messages in the left column of the System and Test Status screen.
Main Menu
→
Status
→
System and Test Status
If
LMI Down, Network
appears for more than three minutes, or any other
network-related status message appears, refer to the status information in the
iMarc SLV
Operations Guide
for possible reasons for the messages and what can be done to resolve the
problem.
If the unit does not have ISDN backup capability, proceed to
Configuring SNMP Trap Managers
and Trap Dial-Out
on page 22.
POWER
COM
DBM
DSX-1
MDM
NET
DSX
ENET
02-17286
RJ48C
Jack
