Zhone EtherXtend 3300 Series, Руководство пользователя

Страница: 47 / 150

EtherXtend User’s Guide
45
B
ASIC
C
ONFIGURATION
This chapter covers basic configuration of the EtherXtend:
•
Device management, page 45
•
EtherXtend auto-provisioning, page 49
•
Customize the EtherXtend default settings, page 53
•
System settings, page 55
•
Device interface, page 61
•
LAN interfaces to CPEs, page 61
•
Moving PC cables on Ethernet ports, page 62
•
Configure an interface on an Ethernet port, page 62
•
IP on a bridge, page 65
Device management
This section describes how the EtherXtend can be managed either through the
the serial interface or the WAN Ethernet ports.
•
EtherXtend local management interface on page 46
•
EtherXtend remote management interfaces on page 46
EtherXtend devices provide interfaces for four or eight WAN SHDSL ports,
four LAN 10/100 Ethernet ports, and a serial port for local management.
After connecting the MALC Ethernet ports on a SHDSL card and the Ethernet
WAN ports on the EtherXtend, the default Autoconfig automatically
configures the interface as a N2N bond group on VLAN 7 as a DCHP client.
Table 13 lists the EtherXtend system default settings.
Table 13: EtherXtend default system settings
Parameter Default setting
Mode CPE Mode
IP Address DHCP enabled on bond group port.
SHDSL Speed 5,696 Adaptive