Zhone EtherXtend 3300 Series, Руководство пользователя

Страница: 48 / 150

Basic Configuration
46
EtherXtend User’s Guide
EtherXtend local management interface
The EtherXtend unit provides an out-of-band RS232 D serial (craft) interface
to manage the unit locally. To access the serial port, configure the terminal
interface software with the following settings:
•
9600bps
•
8 data bits
•
No parity
•
1 stop bit
•
No flow control
You must perform the initial configuration of the system using the serial
(craft) interface. After completing the initial configuration, you can manage
the EtherXtend device remotely through Telent over the network through the
Ethernet management interface or over the management PVC.
Note:
The EtherXtend supports a maximum of two concurrent telnet
sessions and one serial session.
EtherXtend remote management interfaces
This section describes how the EtherXtend can be managed remotely from the
MALC using the default management interface and how to change the
management interface to manage the EtherXtend from a different IP address:
EtherXtend uses the shelf - slot - port - subport / type syntax to identify system
interfaces. For the EtherXtend, the convention is always 1 for the shelf and 1
for the slot value. The subport is always 0. The type is based on the Internet
Assigned Numbers Authority interface type (IANAiftype) definitions.
By default, Autoconfig assigns a bond group number to the N2N bond group
which may vary depending on which port receives the link first. The
Ethernet Interface Autosensing Enabled
Autonegotiating Enabled
Bonding Mode N2N
Login admin
Password zhone
DHCP Client (WAN) Enabled
Table 13: EtherXtend default system settings (Continued)
Parameter Default setting