10
11
www.zj-woq.cn
OPERATIONS
A: Open the outlet valve, close the suction hose cap.
B: Open the pump discharge valve (As Pic 12), connect the Vinyl tube to outlet valve.
C: Put the other head of Vinyl tube to the anti-freeze (about 200ml)
D: Set the throttle to position “start”, let the anti-freeze to enter pump body through vacuum pump. Let air
enter the vacuum pump after 30s’ running; ensure the anti-freeze reach the whole pump.
E: Stop the machine and close the oil valve.
F: Close the handle of outlet valve; stick the anti-freeze on the valve directly.
G: The battery will freeze in low-gravity and the performance will drop in low temperature. Remember to keep
the battery in proper gravity and full charged.
USE ACCESSORIES
1. Battery charger (manual type)
Connect the charger positive (+) and negative (–) cable to the b,– pole (“+” red stigma, “–” black
stigma)
A: Check the electrolytic liquid, clean and tighten the wire.
B: Plug the charger to battery terminals
C: Power the charger to 220AC current. Input light (red) begin to charge
D: The light is off when the battery is full. Turn of the power switch “OFF”, pull out the charge plug.
Note: It takes 4 hours to charge a 50% battery to full.
CAUTION
Place the battery charger on non-flammable table, or fix it on the tall. Do not put on the ground
Connect the charger positive or negative correctly, otherwise it will damage battery and charger.
Keep the battery surface clean at any time.
Battery life is normally 2 years. Replace the battery every 2 year and check its performance.
Connect the battery positive (+) cable BEFORE the negative (–) and disconnect the negative BEFORE the
positive.
The electrolytic liquid is highly corrosive, which damage skin and clothes.
Warning
Charge the battery in good ventilation, not in bad ventilations.
Batteries produce EXPLOSIVE GASES so keep sparks, flames and cigarettes away
Do not charge the battery for long time, which cause explosion.
Security, guaranteed with my presence!
10.
Cover head of the suction hose when the pump is in no use.
11.
Do not put the hand or finger to the mouth of the nozzle
12.
Be careful when moving, lifting or putting the pump, as the fire pump is heavy.
13.
Comply with the operating instructions to clean the spilled fuel.
14.
Battery, gasoline, oil and other harmful elements should be treated through AUTHORISED waste-disposal
contractors to licensed waste disposal sites.
15.
This type of fire pumps do not recommend in building projects, cleaning, irrigation etc.
16.
This type of fire pump is designed for pump water use, not for flammable liquid, chemical liquid or
corrosive liquid.
17.
DO NOT run the engine without water for a long time( no more than.3 minutes), to avoid damaging the
seals.
CAUTIONS AFTER OPERATION
1. Pump maintenance after sea water or sewage)
Clean the pump with clean fresh water after sea water or sewage
2. Check the suction performance
Make sure the water is completely discharged. Close all valves and suction hose capes. Set the throttle to
“MIN” position, open the vacuum pump without water for a while. Check the vacuum gauge normal and stable
to confirm the suction is ok. Stop the machine and open the discharge valve, close it after the vacuum turn to
position”0”
3. Charge the battery
Charge the battery regularly; ensure enough electricity for next use.
4. Refill fuel/oil
Check fuel and oil. Refill them for use at any time.
5. Discharge the oil
Ensure all oil discharged from carburetor, before the pump in warehouse for a long time.
* Turn off the oil tank switch before stopping the engine, close the starting key after the engine stopped.
CAUTIONS UNDER LOW TEMPERATURE
1. Start the engine, which become warmer and in normal operating.
2. Use anti-freeze