Assembling steps
Installing steering wheel:
Connect the power
：
Installing plug
：
Installing the seat
：
Connect the electricity wire on the car to that
of the motor
Connect the red wire to the electricity jar and
the black wire to the black end.
Screw off the 4x12 tapping screw of the
car
Snap the buckle on the back of the
cushion into the neck.
Use two 4x12tapping screws to make it
set
Use the screw driver to unload the M5x35
inorganic screws.
Connect the lead plug-in on the steering wheel to
that of the open holes,and plug the steering wheel
in to the end of the steering tube(pay attention that
the plug-in is along the hole).Make sure the hole
on the steering wheel is lined with the steering
tube,then screw in the M5x35 inorganic screw.
Screw in the M5nut
Push the plug into the hole in the body.
The hole and push on the hole on the body
aligned, penetrating M5 screws with nut.
Note: if you do not push, the installation
is not.
