Assembling steps
The assembling process before using has to be operated by adults.The whole
process takes approximately 30 minutes.
Minute parts has potential danger of choking.Children should be forbidden
touching and playing
！
Tools needed in assembling:screwdriver (self-provided),vice(self-provided)
Before assembling,please check the number of all the parts .The plastic package
should be kept away from children since there’s danger of choking
Installing rear axle and rear wheel:
Rear wheel:
Put the driving gear box into the back-shaft from the left of
the car(make sure the motor cable connector is through the
hole on the car and reach the battery cartridge from the left
of the car)The use of light-emitting wheel will be shining
round power line on the motor through the hole, non
luminous wheel is not required.
Loaded wheel, which coincided with the connector
matching.
Slightly forced by the boss wheels, and the wheels under
pressure, the wheel assembly in place. (remark: pull the
wheel to the outer pull to confirm the wheel assembly in
place)
On the other side of the assembly.
According to the picture,put the spring and spring support into
hole.
Put rear axle through the side hole
Make spring support down,put rear axle through the spring
support’s hole.
The same operation with another spring support.
Loaded wheel, which coincided with the connector matching.
Slightly forced by the boss wheels, and the wheels under
pressure, the wheel assembly in place. (remark: pull the wheel
to the outer pull to confirm the wheel assembly in place)
On the other side of the assembly.
Note: single drive only one drive motor
