Zgonc YELLOW GARDENLINE YGL N.G. 5351, Перевод оригинального руководства пользователя

Страница: 45 / 48

45 GB
12. Troubleshooting
Troubleshooting guide
Problem Probable cause Corrective Action
Unit wonʼt start or starts but
will not run.
Incorrect starting procedures. Follow instructions in the User Manual.
Incorrect carburetor mixture
adjustment setting.
Have carburetor adjusted by an Authorized
Service Center.
Fouled spark plug. Clean / gap or replace plug.
Fuel filter plugged. Replace fuel filter.
Unit starts, but engine has low
power.
Dirty air filter. Remove, clean and reinstall filter.
Incorrect carburetor mixture
adjustment setting.
Have carburetor adjusted by an Authorized
Service Center.
Engine hesitates.
Incorrect carburetor mixture
adjustment setting.
Have carburetor adjusted by an Authorized
Service Center.
No power under load. Incorrectly gapped spark plug. Clean / gap or replace plug.
Runs erratically.
Incorrect carburetor mixture
adjustment setting.
Have carburetor adjusted by an Authorized
Service Center.
Smokes excessively. Incorrect fuel mixture. Use properly mixed fuel (40:1 mixture).
Poor performance when
operated
Blunt chain
Loose chain
Sharpen or replace the chain
Tension the chain
Engine dies
Empty petrol tank
Fuel filter in the wrong position in the
tank
Fill up the petrol tank
Completely fill the petrol tank or or re-
position the fuel filter in the petrol tank
Insufficient chain lubrication
(the cutter rail and chain get
hot)
Empty oil tank for the chain Top up the oil tank for the chain
Oil lubrication openings moved
Clean the oil lubrication hole in the cutter bar
Clean the groove in the cutter bar
13. Admitted saw chain and chain bar
combination
Saw chain Oregon 21BPX078X
Guide bar Oregon 208PXBK095
Storing a chain saw
Storing a chain saw for longer than 30 days requires
storage maintenance. Unless the storage instructions
are followed, fuel remaining in the carburetor will evap-
orate, leaving gum-like deposits. This could lead to diffi -
cult starting and result in costly repairs.
• Remove the fuel tank cap slowly to release any pres-
sure in tank. Carefully drain the fuel tank.
• Start the engine and let it run until the unit stops to
remove fuel from carburetor.
• Allow the engine to cool (approx. 5 minutes).
• Remove the spark plug.
• Pour 1 teaspoon of clean 2-cycle oil into the combus-
tion chamber. Pull starter rope slowly several times to
coat internal components. Replace spark plug.
m
NOTE
Store the unit in a dry place and away from possible
sources of ignition such as a furnace, gas hot water
heater, gas dryer, etc.
Puttig the saw back into operation
• Remove spark plug.
• Pull starter rope briskly to clear excess oil from com-
bustion chamber.
• Clean the spark plug and check that the electrode
gap is correct.
• Prepare unit for operation.
• Fill fuel tank with proper fuel / oil mixture.
11. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material and
can therefore be reused or can be returned to the raw
material system.
The unit and its accessories are made of various types
of material, such as metal and plastic. Defective compo-
nents must be disposed of as special waste. Ask about
recycling in the store or in the local municipal adminis-
tration!