13
•
Pulse rate is flashing (Hz). Press the “UP” or “DOWN” button to change the setting (1 –
150Hz). Press “MODE”.
• Pulse width is flashing (uS). Press the “UP” or “DOWN” button to change the pulse width (30
– 300uS).
•
Once you are done changing the pulse rate and pulse width, press the “MODE” button and
the display stops flashing indicating your programming is finished. The display will show your
final programming.
Note 1 to TENS and EMS programming:
When the device is in use and the “MODE” button is pushed 1 time, it will show the current
programming. To make changes, press the “MODE” button again, all intensity levels will turn to
“0” and the system function will start flashing (TENS or EMS). Please follow above steps to make
changes.
Note 2 to TENS and EMS programming:
If no button is pushed for 10 seconds while in programming mode, the device will stop flashing. To
return into programming mode follow steps above by pressing the “MODE” button.
Note 3 to TENS and EMS programming:
If the device is in programming mode (intensity bars are at “0”), the device will automatically turn
OFF after 60 seconds if no button is pushed.
Chapter 11: PROGRAMMING THE TIMER
To program the timer, follow these steps:
• Press the “TIMER” button and the timer will start flashing.
•
Press the “UP” or “DOWN” button to adjust the time.
•
Press the ”TIMER” button to save the changes or wait 10 seconds until the timer stops
flashing.
