12
Chapter 10: PROGRAMMING YOUR DEVICE AS AN EMS
1. Turn the device ON
•
Press “ON/OFF” button to turn the unit ON.
•
The most recently selected treatment status is displayed.
2. Turn the device OFF
•
The device turns off automatically after the therapy session time has elapsed.
•
The device will turn off after 60 seconds if no button is pushed.
•
To turn the unit off manually, press “ON/OFF” for 3 seconds.
Note:
To prevent unpleasant electric shocks, never move the lead wires or electrodes while the
device is still turned on.
3. System Function Selection
To select the stimulation modality (TENS, EMS), follow those steps:
•
Press the “MODE” button. The device will show your current settings.
• To make changes, press “MODE” again and TENS or EMS will start flashing depending on
your previous setting.
•
To make changes, press the “UP” or “DOWN” button.
• Once you have selected EMS, press “MODE” again and the modes start flashing. Continue
with step 4.
4. Mode Selection for EMS
The device features 3 different modes for an EMS treatment: Synchronous (S), Constant ( C ),
Alternating (A).
• The last selected Mode setting is flashing.
•
To make changes, press the “UP” or “DOWN” button.
•
Once you have selected your Mode, press the “MODE” button again and the ON (sec) starts
flashing. Continue with step 5.
5. Parameter Setting (Treatment time, ON (sec), OFF (sec), Ramp (sec), Pulse rate & Pulse
width)
• ON (sec) time is flashing. Press the “UP” or “DOWN” button to make changes (1 – 30 sec).
Press “MODE”.
• OFF (sec) is flashing. Press the “UP” or “DOWN” button to make changes (1 – 60 sec). Press “MODE”.
• RAMP (sec) is flashing. Press the “UP” or “DOWN” button to make changes (1 – 30 sec).
Press “MODE”.
