8.5 Start-up after carrying out maintenance
work
8.6 Safe operation / risks from prolonged use
6720871998 (2019/10)
22
to replace.
ÿ Replace.
ÿ Check that there are no gas or water leaks.
ÿ Carry out a visual inspection between maintenance intervals.
The user should never touch the device.
ÿ Wait 10 minutes and switch the appliance back on.
– combustion chamber
Description Solution
Device does not ignite.
Worn batteries.
Problems
Under no circumstances should the device be disconnected,
damaged or replaced with a different part.
Prolonged use increases the wear of some elements and can
cause gas leaks and overflow of combustion products.
DANGER:
Water heats little, flame is dead. Insufficient gas supply.
ÿ Check the exhaust circuit for tightness (with the
– water valve
ÿ Ventilate the compartment.
Assembly, maintenance and repair must only be carried out by
specialized and qualified technicians. The following table
describes solutions to possible problems.
On/off switch flashes.
Water heats up little.
The probe resets itself after a cooling period.
– electrical contacts of safety probes
ÿ Read chapter 4 "Instructions for use" and chapter 7.1
"Adjusting the device".
ÿ Call a specialized and qualified technician.
ÿ Replace.
front placed).
Operation and precautions
First you must:
Intoxication!
Problem
ÿ Check the position of the temperature
selector and adjust according to the
desired water temperature.
When it is damaged, replace it.
Intoxication!
tion.
Badly placed, worn-out batteries or switch ÿ Check battery position and/or off.
Worn batteries.
ÿ Check the gas regulation (burner pressure).
If the device switches off during use:
– gas valve
Pilot burner ignition slow and difficult.
ÿ Check whether the bottles (Butane)
freeze during operation, if so, move
them to a less cold place.
DANGER:
ÿ Retighten all connections.
attention to the following elements:
This device checks the conditions for evacuating burned
gases and, if these are deficient, it automatically turns off the
device, preventing combustion gases from entering the
compartment where the device is installed.
In case of visible corrosion, you must:
ÿ Check switch position.
ÿ Check the reducer and, if unsuitable,
9 Problems
Machine Translated by Google