Treadmill
10811
Instructions for Use
Please read and retain these instructions for future reference
v004
: 04/09/20
letting go of them.
To stop the treadmill:
- using the control panel decrease the speed until it stops
- hit the emergency stop switch.
- hold on, step onto the side rails and turn off treadmill.
Keep a 2m area around and behind the treadmill clear of objects.
MAINTENANCE:
Turn off the power and unplug before daily maintenance.
Do not use formaldehyde or organic solvent to clean to avoid damage to the fittings.
Use a clean, dry cloth to remove any sweat you have left behind on the treadmill's deck or
handrails to prevent corrosion of the equipment.
To remove stubborn stains, oil or dirt, wipe off with a cotton cloth with cleanser and wipe
dry.
Around the power switch and control panel, please use a soft and dry cloth to clean. Do not
use a damp cloth.
Do not use the treadmill in a moist or dust intensive environment which may lead to
mechanical failure.
Place on a flat surface.
Regularly clean to remove dust in order to keep components clean. Clean both sides of the
exposed part of the running belt to reduce accumulation of debris.
Wear clean sports shoes to avoid transferring debris onto the running belt.
Use soap and a cleaning cloth to clean the running belt. Do not use cleaner.
Wipe sweat off the handrail and the running belt after using the treadmill.
The running board and running belt have been treated with anti-static lubricants. It is
recommended users use an anti-static silicon lubricant (not included) on a regular basis, at
least every 3 months.
How to Lubricate Your Treadmill Belt
Pull the treadmill belt away from the deck with one hand and with the other hand, insert the
silicone spray nozzle underneath the belt and spray the silicone towards the centre of the
belt.
Follow this procedure spraying up and down both sides of the running belt, applying a total
of 1-oz of anti-static lubricant.
Rotate the belt by hand one-half a revolution so that you reach the portion of the running
belt that was not lubricated, then repeat the treadmill lubrication process.
When complete, run the treadmill for approximately 3 minutes at 3 mph, distributing the
silicone across the running belt and deck.
Note: When lubricating the treadmill belt, make sure the treadmill is located on a surface
that can be easily cleaned.
After treadmill lubrication, clean any excess silicone off the belt and frame.
We recommended you wipe the treadmill down after each use to keep the treadmill clean
and dry.
A mild detergent may be used at times to help remove all dirt and salt from the belt, painted
parts, and the console.
Adjusting the running belt
The treadmill might need adjustment to work best as sometimes there may be deviation in