ZETRON 640 DAPT XTRA, Руководство по установке и ремонту

Страница: 77 / 210

Installation
025-9416 65
q 3. Use bridging clips or wire to connect the middle terminal of each row, as needed.
q 4. Trim any excess wire from each punchdown terminal to ensure good electrical
contact.
q 5. Label the punchdown block or leads to identify each of the radio signals. This will
simplify troubleshooting and repair later.
q 6. Either make an appropriate cable and connector for the radio station interface or
directly cross-wire the punchdown terminals to the radio equipment. The type of
connection is governed by the specific equipment used. Refer to “RF EQUIPMENT
INTERFACING” on page 66 for details on many of the possible transmitter
equipment interfaces.
Note: Zetron recommends using stranded wire for the radio station interface, as it provides
superior durability. The wire should be at least 14 gauge. It is also useful to have
different colored wrap to easily identify each signal lead.