![background image](http://html1.mh-extra.com/html/zetron/4000-series/4000-series_installation-manual_3536674281.webp)
281
System-Specific Definitions
Setting the Alarm Acknowledge and Annunciation
From the entry form presented within the main menu, the Alarm Setup menu selection
allows you to specify several actions when alarm input is detected and when an alarm is
Figure 60: Alarm Setup window
Alarm Setup
An Auxiliary output may be activated for a short time when the console Alarm
Acknowledge key is pressed (
Alarm Acknowledge Output
). If no acknowledge output is
needed, this field can be left blank. The
Alarm Acknowledge Time
can be set to limit the
number of seconds (1-100) that the acknowledge output is activated.
In addition to the console display of an alarm message, you may specify an Aux Output to
be activated when an alarm is detected (
Alarm Annunciator Output
). This could be used
to energize a buzzer, horn, flashing lamp, etc. The annunciator output will stay active until
the alarm is acknowledged.
You may specify an alert tone to be generated through the console speakers when an alarm
is detected. This alert can be a series of beeps (select
Beep)
or one of a set of pre
programmed alert tones (select
Tone
). If
Beep
is selected, then the
Alert Beep Count
may
be specified. If
Tone
is selected, then you may select from one of six different tone types
(
Alert Tone Type
).
Cross Muting
Channels common among operator positions can be muted when transmission is
occurring. Cross muting eliminates feedback problems related to operator positions, which
are physically too close.
Tip
Navigate to this area from the main window in RDPS by clicking on
Alarm Setup
.
Tip
Navigate to this area from the main window in RDPS by clicking on
the
CCE cards
in the upper right, then
Cross Muting
.
Содержание 4000 Series
