Zeta Alarm Systems ZD-CO-9B, Руководство пользователя

Страница: 11 / 22

10
way in which these products burn means
the smoke given off contains a detectable
localised amount of carbon monoxide.
Alternative sources of smoke, for example
an extinguished candle or match, will not
contain sufficient levels of carbon monoxide
to obtain a response from the detector during
this test. Please note your CO detector will not
detect smoke.
If testing the sensor for the first time after
installation, or replacing the batteries, make
sure that the alarm has completed the initial
3 minute warm up period and the power LED
is flashing green once every minute.
CAUTION:
Sensor testing should only
be performed by a responsible adult.
This test should be performed annually.
NOTE:
CO test kits may be used in
order to avoid having to burn incense
sticks or cigarettes. However we recommend
that incense sticks are used as they are cheap
and readily available.
• Read all steps thoroughly before attempting
to test your the sensor
Step 1
If the detector is wall or ceiling
mounted unhook the detector from
the screws.
Step 2
Cover the sounder vents with one
hand. Press and hold the Test/
Reset button down with your
thumb/finger until the Power LED
illuminates green and the sounder
sounds for a second time (this
should happen after around 5
seconds). Release the Test/Reset
button. Upon releasing the Test/
Reset button the Power LED will
flash green once every second.
This indicates that the sampling
rate of the detector has increased
and can be tested using a known
source of CO.
Step 3 Light an incense stick or cigarette
using a match or lighter. If using
an incense stick be sure to blow
out the flame so that the incense
stick is smouldering. Extinguish
the lighter, or put out the match
and place it into a dish of water.
Step 4 Turn the detector on its side
so that the vents on the right
Test/Reset
Button