zesto CE 2416, Инструкция по эксплуатации и обслуживанию для владельца

Страница: 4 / 27

REF #0907-53
SAVE THESE INSTRUCTIONS FOR FUTURE USE
GENERAL:
Read these instructions and keep them for future reference. Before installing the oven, consult your
local building authority and obtain a building permit if necessary. Do not modify or alter the construction of the oven
or any of its components. Install the oven as described in these instructions. Use only
ZESTO components.
Failure to do so will void the Certification approvals and the warranty of this oven.
PURCHASER’S RESPONSIBILITY
1. To see that the electric services for the oven are installed on site in accordance with the manufacturer’s
specifications.
2. To unload, uncrate and install the oven in its proper location in accordance with the Installation Operation
Manual.
3. To see that the electric services are connected properly by a qualified licensed ELECTRICIEN or installer of
your choice. All such connections must be in accordance with applicable Code requirements.
4. Do not attempt to operate the oven until connection of utility service has been fully inspected by an authorized
service technician.
INSTALLATION WARNING:
Input voltage and phasing must
match the units voltage & phasing.
Remove back panel and pass the
service line through the rear of the
unit and connect to the teminal block.
WARNING:ADEQUATE MEANS MUST BE PROVIDED TO LIMIT THE MOVEMENT OF
CASTERED APPLIANCES. A RESTRAINING DEVICE IS REQUIRED FOR ALL TYPES OF
MOVEABLE APPLIANCES.
WARNING:
*
INSTALLATION AND REPAIR SHOULD BE DONE BY A QUALIFIED SERVICE PERSON.
THE APPLIANCE SHOULD BE INSPECTED BEFORE USE AND AT LEAST ANNUALLY
BY A QUALIFIED SERVICE TECHNICIAN. MORE FREQUENT CLEANING MAY BE
REQUIRED DUE TO OVEN GREASE VAPORS, DUST, ETC. IT IS IMPERATIVE THAT
CONTROL COMPARTMENTS, BURNERS AND CIRCULATING AIR PASSAGEWAYS OF
THE OVEN BE KEPT CLEAN.
* DO NOT MODIFY THIS APPLIANCE.
* DO NOT BLOCK THE AIR REGISTERS ON THE OVEN AS THIS WILL CAUSE THE OVEN
TO OVERHEAT.
WARNING: DO NOT USE THIS APPLIANCE IF ITS CONTROL HAS BEEN UNDER WATER.
IMMEDIATELY CALL A QUALIFIED SERVICE TECHNICIAN TO INSPECT THE APPLIANCE
AND TO REPLACE ANY PART OF THE CONTROL SYSTEM WHICH HAS BEEN UNDER
WATER.
VENTILATION:
1. Ventilation hood should extend 6" (15cm) minimum past the oven on the front and back and 6" (15cm)
minimum past each side of the conveyor belt and hung 6’6" (198cm) above the floor surface.
2. Exhaust - Approximately 2000 CFM required for double stacked ovens.
Approximately 1500 CFM required for single oven.
Make-up air should be 65% - 80% of the exhaust air rating.
4