Zesto Audio 2021 Page #5
12.
LIGHTNING:
For added protection during a lightning storm or when the component is idle for long periods
of time, unplug the unit from the wall outlet. This will help protect the unit from lightning and power line
surge damage.
13.
POWER LINES:
Do not locate an outside antenna system in the vicinity of overhead power lines or other
electric light or power circuits. When installing an outside antenna system, take extreme care to avoid
touching the power lines or circuits; contact with them could be fatal.
14.
OVERLOADING:
Do not overload wall outlets, extension cords, or integral convenience receptacles as
this increases the risk of fire or electric shock.
15.
REPLACEMENT PARTS:
When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer or those having the same characteristics as the original
parts. Unauthorized substitutions may result in fire, electric shock, or other hazards.
16.
SAFETY CHECK:
Upon completion of any service or repairs to the unit, ask the service technician to
perform safety checks to ensure the unit is in proper operating condition.
17.
IMPORTANT SAFETY NOTE:
• Before connecting a new product such as the Andros Téssera Reference Phonostage to your audio or
home theater system, turn off all other equipment (preferably unplugging them from the AC power
source). Many audio components feature automatic turn-on circuits that may activate during an
installation, potentially causing damage to electronic components or speakers. This type of damage is
not covered by product warranties, and Zesto Audio specifically disclaims responsibility for any such
damage.
•
Power Cord:
The removable IEC power cord provided with your unit was specifically designed for use
with this product, but other AC cords may be used. Consult your dealer for advice on AC power cords
and high-quality wire in your system.
•
AC Fuse:
The fuse is located inside the drawer of the IEC power entry connector.
IMPORTANT
: Only Slow Blow fuses can be used in this equipment. If the unit does not power up,
contact an authorized service representative.
•
Wiring:
Cables running inside walls should have the appropriate markings to indicate compliance and
listing by the UL, CSA or other standards required by the UL, CSA, NEC, or your local building code.
Questions about cables inside of walls should be directed to a qualified custom installer, licensed
electrician, or low-voltage contractor.
18.
RECORDING COPYRIGHT:
Recording of copyrighted material for other than personal use is illegal
without permission of the copyright holder.
19.
FCC INFORMATION FOR USER:
•
CAUTION:
Any changes or modifications not expressly approved by Zesto Audio could void the user's
authority to operate the equipment.
• These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy, and if not installed and
used in accordance with the instructions it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the equipment.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from where the receiver is connected.
