Zero FX 2015, Руководство пользователя

Страница: 53 / 136

General Operation
4.9
Add On Electrical Equipment
CAUTION:
Do not add electrical components to your
motorcycle unless approved by an approved Zero
Motorcycles dealer. Some add-on electrical components
can damage your motorcycle, prevent other components
from working as they should, and/or dramatically reduce
the range and/or life expectancy of the power pack.
Power Pack Charger
Connect your power pack to the charger after each use.
Once recharged, disconnect from the AC power source.
Leaving your motorcycle unplugged between charges will
maximize the long-term health of the power pack. You
should use the supplied cable as it is designed for use with
your motorcycle’s electrical components. The power pack
must be charged within 24 hours if fully discharged. If you
don’t ride for an extended period of time (30 days or more),
you may want to plug the motorcycle into an AC power
source to charge it for a few hours prior to your next ride.
CAUTION: Only charge the Zero power pack with the Zero
charger. The charger is located under the power pack.
When charging the motorcycle’s power pack, the charger
can be left ON, even after the power pack is fully charged.
But unplugging your motorcycle after it is fully charged will
maximize long-term power pack health. If left connected,
there are two possible cases that can occur:
•
When connected to the charger, the power pack will
receive a full charge. Once fully charged, the charger
will cycle between 90% and 100% state of charge.
When the state of charge gets close to 90%, the
charger will recharge to 100% and repeat. When fully
charged, a green light illuminates on the charger.
Should the charger not read that the power pack is full,
it continues to attempt to fully charge the power pack.
In this event the green light may not illuminate;
however, the power pack may be fully charged. To
ensure that the power pack is charged, check the
charge indicator on the dash display prior to riding.
•
If the power pack terminates the charge before the
charger reaches the state previously mentioned, then
the charger will continue to cycle and will top off the
power pack until the power pack is removed from the
charger, or the charger reaches the complete state
previously noted.
Zero Owner's Manual (FX).book Page 9 Thursday, April 5, 2018 1:40 PM