ZERO-X Rapture ZXRAP, Руководство пользователя, Страница: 9 / 24

1 1
7
Set Up
Charging the Battery
Unwind & plug the included USB charger into a powered USB port. You can connect
the USB charging cable to either a computer USB port,
USB C-Tick certiied DC
5V/2.1A output wall charger or USB power bank . Use only use the USB charging
cable included with the Rapture drone. When connected to a charging source the
LED light in the charger will glow green. Connect the drone battery to the charger
and the light will glow red indicating charging is in process. The LED on the USB
charger will begin to glow green again once charging is complete. To keep the
battery life as long as possible avoid removing the battery from the charger before
charging is complete.
• If the battery is being charged by computer, make sure to pull out the USB
cable if you want to shut down the computer.
• When connecting the USB cable with the battery, make sure to follow the
correct polar indicator.
• When Flying the Rapture drone, low battery will be indicated when the remote
control starts beeping and the lights on the Rapture drone start lashing.
When using a Wall charger, please ensure
that only an Australian Standards, C-Tick
certiied charger is used. Incorrect charging
or overcharging of battery could lead to
serious failure of the battery.
Installing the Rapture Battery
• Ensure that the Rapture drone’s power
switch (5) is in the OFF position.
• Connect the battery cable to the Rapture
drone’s power cable ensure that the plug is
inserted in the correct orientation.
• Tuck the cable into the battery opening.
• Insert the fully charged battery with the
charging wires facing outwards.
• Connect the battery cable to the Rapture
drone’s power cable.
• Close the battery hatch making sure the
door clicks into place.
For information on the Remote Control
Battery, see section marked Remote
control