ZERO-X Rapture ZXRAP, Руководство пользователя

Страница: 12 / 24

10
Launching your Rapture drone
1. After installing a fully charged battery into the Rapture drone and Remote
Control and conducting a complete check of your surroundings, turn the Power
Switch (5) on the Rapture drone to the ON position.
2. Once the Rapture drone is powered on, the LED lights on the arms should lash,
signalling no connection to the Remote Control. Place the Rapture drone on lat
ground facing away from you and move back three meters.
3. With the Left Thumbstick (Acceleration/Yaw) (2) in the lowest (down) position,
power on the Remote Control, the remote should beep once to indicate power
up has been successful.
4. To activate the connection between the Remote Control and the Rapture drone,
move the Left Thumbstick (Acceleration/Yaw) (2) on the Remote Control to the
highest (up) position, hold for one second and then return the Left Thumbstick
(Acceleration/Yaw) to the lowest (down) position holding for another 5 seconds.
The remote should beep three times, the lights on the arms of the Rapture
drone should shine solid and the power indicator light on the Remote Control
will shine solid indicating that the connection has been successful.
5. Calibrate the Rapture drone by holding the Right Thumbstick (Pitch/Roll) (3)
in the bottom right position. This ensures that the Rapture drone stays level and
lies straight. The Lights on the Rapture drone will lash fast while calibrating.
Keep holding the Thumbstick in the bottom right position until calibration
is complete.
If the Rapture drone starts to ly abnormally, it may need to be re-calibrated.
To recalibrate the Rapture drone turn the Remote Control and Rapture drone
off, and then restart the Launching your Rapture drone process.