Zero Motorcycles XU 2012, Руководство пользователя

Страница: 81 / 142

5-6
LOWER
A
B C
General Maintenance
Motor (MX)
CAUTION: Wear safety glasses when using
compressed air to avoid eye injuries.
The motor requires little maintenance, but dust can
collect inside the motor and can cause premature
brush wear. If you ride in dusty conditions, it is
important to blow the dust out of the motor with
compressed air. Do this only in a well-ventilated area.
Brakes
Brake Fluid Level Inspection
WARNING: Do not spill brake fluid on painted
surfaces; the finish could be damaged. Spilling brake
fluid on the ABS body plastic will cause them to
crack. Clean off any brake fluid spills immediately.
Always place a shop towel under the master cylinder
reservoir prior to removing the cap/cover.
Low fluid levels may indicate worn brake pads or a
leak in the hydraulic system. Inspect the brake pads
for wear and/or the hydraulic system for leaks. Use
only new DOT 4 brake fluid from a sealed container.
Front Brake
Inspect the level of the
front brake fluid through
the sight glass (B). If
the fluid level is visibly
below the low level
indicator (C), brake fluid
must be added. Clean
any dirt or debris from
the cover (A) before
opening the reservoir.
1. Remove the two Phillips screws that secure the
cover onto the reservoir.
2. Add new DOT 4 brake fluid.
3. Inspect the cover seal, ensuring that it is free of
any wear or damage and that it is positioned
correctly.
4. Install the cover and tighten the Phillips screws.