The device should be checked immediately after delivery for damages which might have
occurred during transportation. Please contact your supplier immediately if damages can be
identified.
The device should be cleaned properly before setting it into operation. For this, lukewarm water
and a mild cleaning agent must be used only. Abrasive or caustic cleaning agents, steel wood,
scouring sponges, or chemical cleaning agents should in no case be used. After the cleaning is
finished, the device should be dried properly.
Ensure that the device is placed at a cool location, away from heat sources, and not being
exposed to direct sunlight. The room must be ventilated properly. The device must not be
exposed to air draught conditions. The unit covering, i.e. the venting slots and the chimney
opening must not be blocked.
To ensure proper function, the device must be standing horizontally. Use a water level to check
and to correct if necessary.
2 aluminum and 2 water isolating inserts are included with the delivery. The use of these isolating inserts
is subject to the ambient temperature.
Use the water isolation inserts at ambient temperatures up to +32°C.
Use the aluminum & plastic isolation inserts at ambient temperatures higher than +32°C (up to
+43°C at maximum).
The isolation inserts must be pushed into the slot on the left and right side of the freezer section.
2 isolation inserts must always be installed. If only one isolation insert is installed, the temperature in the
cooling section without an isolation insert will become too
cold.
The plastic isolation inserts must be filled up to the indicated
maximum level with cold, clean water before starting
operation. Do not fill the isolation inserts completely! The
upper section must be kept Free.
Page 3
I
NSTALLATION
I
NSTRUCTIONS
I
NSTALLATION OF THE
I
SOLATION
I
NSERTS
