Zepro Z 1500, Руководство по установке, Страница: 25 / 68

Z 1500/2000-135/155/175 Installation
25 www.zepro.com
Locking screws, 3 pcs.
Out
In
Figure 38. Adjusting the fit to the vehicle body
Figure 39. Adjusting the tilt angle
4. Turn the adjuster sleeve until the platform fits
perfectly against the seal on the body. Figure 38.
5. Undo the three locking screws on the other tilt
cylinder. Figure 39.
6. Turn the adjuster sleeve until the tilt cylinder
aligns with the platform attachment point. See
Figure 39.
IMPORTANT
!
The max. length of both cylinders must be adjusted
equally to avoid unwanted bending forces.
7. Install the other tilt cylinder on the platform at-
tachment point. Use the shaft and support wheel
supplied.
8. Tighten the bolts using a torque wrench.
Tightening torque: 80 Nm.
9. Adjust both cylinders alternately until the plat-
form touches the vehicle body; see Figure 38 (B).
10. Tighten the adjuster sleeve locking screws using
a torque wrench Tightening torque: 3-5 Nm.
Figure 40. Install the tilt cylinder on the platform
IMPORTANT
!
Make sure the cylinder is installed with the grease
nipples facing up.
Lubricate the bushings and shaft! Use LE lubricant
4622 or the equivalent.