Zeppelin Design Labs VPM-1, Руководство пользователя

Страница: 21 / 28

21
4. MAIN BOARD MODULE
a. Attach the ribbon cable to the main board header (33). Remember earlier when you noted
the pattern on the cable wire near the dot on the sensor board? It is important that the pin by
the dot on the sensor board is attached to the pin by the dot on the main board. Make sure it
is not reversed.
33
b. Slide the main board chassis into the VP Jr chassis and screw it in place with the short screws
(34,35).
34 35
That’s it!
You are almost ready to go. Move on to “APPENDIX 2: CALIBRATING THE VPM-1” on page 22.