20
Spruce Use, Care, and Installation Guide
S P R U C E
I N S E R T
P R O
Troubleshooting
Possible Problem
Possible Cause
Solutions
After installation, the
unit doesn’t work.
The power source is not turned
ON.
Make sure the circuit breaker and the
unit’s power is ON.
The power line and the cable
locking connector is not
connecting properly.
Check the power connection with the
unit is connected properly.
The switch board wirings are
disconnected.
Make sure the wirings at the switch
board are connected properly.
The switch board is defective.
Change the switch board.
Light works, but
blower is not turning.
The blower wire is not connected. Make sure the blower wire is plugged
into the molex connector.
The thermally protected system
detects if the blower is too hot
to operate and shuts the blower
down.
The blower will function properly after
the thermally protected system cool
down.
Damaged capacitor.
Change the capacitor.
The blower is defective, possibly
seized.
Change the blower.
The unit is vibrating.
The blower is not secured in place. Tighten the blower in place.
Damaged blower wheel.
Replace the blower.
The hood is not secured in place.
Check the installation of the hood.
The unit is whistling.
A filter is not in the correct
position.
Adjust the filters until the whistling stops.
The duct pipe connections are not
sealed or connected properly.
Check the duct pipe connections to be
sure all connections are sealed properly.
The blower is working,
but the LumiLight
LEDs are not.
The LumiLight LED connector is
disconnected.
Connect the LumiLight LED connector.
Defective LumiLight LED.
Change the LumiLight LED.
The switch board is defective.
Change the switch board.
