Zenza Bronica SQ-Am, Руководство пользователя

Страница: 7 / 31

B. To detach the lens, press the lens release button down and, at the same time, rotate the lens in the clockwise direction until it
makes a full stop, at which point it will be possible to detach the lens.
4.
Functions on the Hand-Grip
A. The mode selector switch has three settings, or OFF, Sm and Cm. When set to OFF, all power is switched OFF and autowinding,
lens shutter operation and the built-in exposure meter of attached finders will not function. When set to Sm, there is single
exposure operation and when set to Cm, there is continuous exposures while the shutter release button is depressed.
B. The drive button is used to set the loaded film to the first frame to be exposed, after it is aligned to the start-mark, to advance
the film for multiple exposures, etc.
C. When there is abnormal overload on the motor during film winding operations, etc., the motor will stop and the redcolored
overload warning LED will light up. Therefore, move the mode selector switch to OFF, check for the cause of the overlaed and
rectify it. Then, set the mode selector switch to Sm or Cm and it will be possible to continue shooting.
OFF, check for the cause of the overload and rectify it. Then, set the mode selector switch to Sm or Cm and it will be possible to
continue shooting.
D. The accessory shoe is a hot shoe type which means that electronic flash units with proper terminals can be used without
connecting cords. However, the contact cover on the hot shoe must be removed, first, when attaching electronic flash units.
E. Depress the shutter release button gently, with the ball of the finger.
When the shutter release button is stroked gently and smoothly, it will be possible to confirm the shutter speed setting in the
viewfinder area of the AE Prism Finder S, when it is attached.
5
Shutter Release
Warning LED