12
1045 - 001 -
01.06.2020
Refueling
1. Place the machine to be refueled on a flat surface
outdoors and settle it.
2. Clean the area around the fuel tank cap.
3. Loosen the fuel tank cap slightly to remove the
pressure difference between the inside and outside
of the fuel tank.
4. Shake the fuel container well to mix perfectly.
5. Remove the fuel tank cap and refill little by little to
80 % of the fuel tank.
6. After refueling, tighten the tank cap securely and
check that there is no fuel leakage.
7. Start the engine at least 3 m away from the refueling
location. Refer to
Starting procedure on page 12
.
Note: To find the location of the fuel tank, refer to
Product overview - HT220-75 on page 3
Product overview - CHT220-60 on page 4
Handle adjustment CHT220-60
The rear handle can be adjusted to three different
angles.
● Release the handle lock and turn the handle.
Starting procedure
WARNING: Always start the machine at
least 3 m from the refueling area.
WARNING: Keep people out of the work
area without permission. There is a risk of
serious injury. The safety distance is 15 m.
WARNING: Always keep the throttle lever in
the idling position when starting, stopping
the engine, or moving the machine. It is
extremely dangerous if the throttle lever is
set to any position other than the idling
position, as the blades will start moving
when the engine starts.
1. Move the choke lever to the closed position.
Note: If restarting the machine immediately after
stopping the engine, the choke can be left in the
open position.
2. Repeat pressing and releasing the primary pump
with the operator's finger until fuel begins to return to
the tank through the clear pipe.
Note: No pump operation is required when restarting
immediately after the engine is stopped while fuel
remains in the tank.
