17
4. Service Guide
4-1 Starter Pulley Removal
HB23 Series, EBZ30 Series
●
Insert the stopper (special tool) into the plug hole
(refer to “3 Special Tool”) to secure the piston.
●
Remove the starter pulley using commercially
available pliers. The pulley must be covered with
cloth to prevent from damage.
Never remove the starter pulley by hitting
with a hammer.
Doing so may damage the pulley.
EB4300/ 6200, EB70 Series, EBZ4800, EBZ51 Series
●
Insert the stopper (special tool) into the plug hole
(refer to “3 Special Tool”) to secure the piston.
●
Remove nut (M10), set a commercially available
puller, then remove the starter pulley.
Never remove the starter pulley by hitting
with a hammer.
Doing so may damage the pulley.
4-2 Air Inlet Net Removal
EB6200, EB70 Series, EBZ4800, EBZ30/ 51/ 71/ 80 Series
The air inlet net is mounted by four clips.
The removal procedure is shown below.
1. Loosen each clip’s resin screw and remove the
whole.
Set the Philips screwdriver against the resin
screw securely. Insufficient or excessive
contact may cause the resin head to break.
2. Insert a screwdriver between free flow net and
frame, then wrench the clip open by twisting the
screwdriver.
Pay attention not to damage the air inlet net
or frame with the screwdriver.
CAUTION
CAUTION
Pliers
Cloth
Starter Pulley
Box Wrench
Nut (M10)
Starter Pulley
Puller
Starter Pulley
CAUTION
CAUTION
Resin Screw
【
【【
【
Clip Position
】
】】
】
Clip
Air Inlet Net
Screwdriver
