Zenoah GZ3500T, Руководство по ремонту

Страница: 31 / 56

English –
31
Repair instructions
Fig 16
7.8 Assembling the ignition module and
the flywheel
1
Fit the flywheel onto the crankshaft journal. Turn
the flywheel until the key goes into the keyway on
the shaft.
Fit the nut H, tightening torque 20-25 Nm, see figure
14.
2
The ignition module must be fitted as follows:
Turn the flywheel so that the magnets are positioned
opposite the ignition module. Fit the spacers, see
figure 11. At the same time, fit ignition module C
and plastic feeler gauge K. Fit the earthing cable F in
screw D as shown in figure 15. Tighten the screw D,
tightening torque 4.5-6 Nm. Remove the plastic feeler
gauge. Fit the ignition cable E on ignition module
C. Set the distance 0.3+/-0.1 mm, between ignition
module and magnet. The measurement applies to the
two lugs on the ignition module. Remove the plastic
feeler gauge.
3
Unscrew the piston stop and assemble the spark
plug. Note! The earthing and electrical cable must
be fitted into slot L.
Note! Fit the cable M into the slot on the air wire as
shown in figure 16.
4
Then fit:
• spark plug cap
• air wire
• starter, tightening torque 2.5-3.5 Nm
When replacing the cables, they are fitted on the stop
switch as shown in figure 24.
Fig 14
Fig 15