![background image](http://html2.mh-extra.com/html/zenoah/g2500/g2500_owners-manual_3401241015.webp)
G2500 / G2500 OPS
GB-15
G
B
When returning the filter, use a pinch not to be folded the suc-
tion pipe.
3. Oil filter
1.
With a wire hook, take out the oil filter from the feeding
port.
2.
Wash the filter with gasoline.
When returning the filter, use a pinch not to be folded the suc-
tion pipe.
4. Spark plug
Clean the electrodes with a wire brush and reset the gap to
0.6 mm as necessary.
5. Sprocket
Check for cracks and for excessive wear interfering with the
chain drive. If the wear is considerable, replace it with new
one. Never fit a new chain on a worn sprocket, or a worn chain
on a new sprocket.
2. Fuel filter
(a) Using a wire hook, take out the filter from the filler port.
(b) Wash the filter with gasoline.
Replace with new one if clogged with dirt completely.
Before cleaning, the inspecting or repairing the unit, make sure
that engine has stopped and is cool. Disconnect the spark
plug to prevent accidental starting.
■
MAINTENANCE AFTER EACH USE
1. Air filter
Loosen the knob and remove the air cleaner cover. Take off the
filter elements and tap off attached sawdust. When they are
extremely dirty, shakewash with gasoline. Dry them completely
before reinstalling.
2. Oiling port
Dismount the guide bar and check the oiling port for clogging.
3. Guide bar
When the guide bar is dismounted, remove sawdust in the bar
groove and the oiling port.
<Type : sprocket nose>
Grease the nose sprocket from the feeding port on the tip of
the bar.
4. Others
Check for fuel leakage and loose fastenings and damage to
major parts, especially handle joints and guide bar mounting.
If any defects are found, make sure to have them repaired
before operating the saw again.
Oil filter
7. Maintenance
Oiling port
Champion
RCJ-7Y
Oiling port
Grease port
Sprocket
■
PERIODICAL SERVICE POINTS
1. Cylinder fins
1.
Remove the starter case.
2.
Remove sawdust between the cylinder
fins.
3.
Clean the valute area.
Fuel filter
6.
Way of the cooling air
• The engine metal parts can burn your skin. Never touch the
cylinder, muffler or ignition plug etc. during operation or right
after stopping the engine.
• Before starting the engine, check around the muffler and
take off sawdust. If you do not, it will cause the overheating
and a fire. For preventing the trouble, please keep clean
around the muffler.
This engine is air-cooled. Dust clogging between the inlet port
of the cooling air and cylinder fins will cause overheating of
the engine. Periodically check and clean the cylinder fins after
removing the air cleaner and the cylinder cover.
When installing the cylinder cover, make sure that switch wires
and grommets are positioned correctly in place.
inlet port of the cooling air
IMPORTANT
WARNING
WARNING
WARNING
WARNING