GB-6
BKZ315L
the cutting attachment begins to
rotate as soon as the engine is
started by putting the throttle
lever into the start position. When
starting the engine, place the
product onto the ground in a flat
clear area and hold it firmly in
place so as to ensure that neither
the cutting part nor the throttle
lever come into contact with any
obstacle when the engine
starts.
WARNING
Never place the throttle lever into
the high-speed position when
starting the engine.
3. After starting the engine, check
to make sure that the cutting at-
tachment stops rotating when the
throttle is moved fully back to its
original position. If it continues to
rotate even after the throttle lever
has been moved fully back, turn
off the engine and take the unit
to your authorized ZENOAH
servicing dealer for repair.
■
USING THE PRODUCT
IMPORTANT
Cut only materials recommended by
the manufacturer. And use only for
tasks explained in the manual.
1. Grip the handles firmly with both
hands using your whole hand.
Place your feet slightly apart
(slightly further apart than the
width of your shoulders) so that
your weight is distributed evenly
across both legs, and always be
sure to maintain a steady, even
posture while working.
2. Keep cutting attachment below
waist level.
3. Maintain the speed of the engine
at the level required to perform
cutting work, and never raise the
speed of the engine above the
level necessary.
4. If the unit starts to shake or vi-
brate, turn off the engine and
check the whole unit. Do not use
it until the trouble has been prop-
erly corrected.
5. Keep all parts of your body away
NOTE
Check and follow the local regula-
tions as to sound level and hours of
operations for the product.
■
BEFORE STARTING THE
ENGINE
1. The area within a perimeter of 15
m of the person using the prod-
uct should be considered a
hazardous area into which no
one should enter. If necessary,
yellow warning rope, warning
signs should be placed around
the perimeter of the area. When
work is to be performed simulta-
neously by two or more persons,
care should also be taken to
constantly look around or other-
wise check for the presence and
locations of other people working
so as to maintain a distance
between each person sufficient
to ensure safety.
2. Check the condition of working
area to avoid any accident by
hitting hidden obstacles such as
stumps, stones, cans, or broken
glass.
IMPORTANT
Remove any obstacle before begin-
ning work.
3. Inspect the entire unit for loose
fasteners and fuel leakage. Make
sure that the cutting attachment
is properly installed and se-
curely fastened.
4. Be sure the cutting attachment
guard is firmly attached in
place.
5. Always use the harness. Adjust
the harness for comfort before
starting the engine. The harness
should be adjusted so the left
hand can comfortably hold the
handlebar grip approximately
waist high.
■
STARTING THE ENGINE
1. Keep bystanders and animals at
least 15 m away from the operat-
ing point. If you are approached,
immediately stop the engine.
2. The product is equipped with a
centrifugal clutch mechanism, so
5. For safe operation
01-BKZ315L_GB_cs6＿二.indd 6
18/09/03 11:50
