GB-10
BKZ315L
6. Set up
■
MOUNTING THE HANDLE
1. Mount the loop handle on the main pipe in accor-
dance with the serial-number label. Turn the grip and
tighten it slightly, then fasten the hanger plate to-
gether in the position shown in SE8.
2. Adjust the position of the loop handle to the position
where you can work easily, and tighten the loop
handle firmly.
(1) Grip
(2) Hanger plate
WARNING
• Tighten the grip firmly. If the grip becomes loose,
it might move while you are working, causing
danger.
• Do not loosen or twist the grip while you are work-
ing.
• Always stop the engine and make sure the blade
has stopped before adjusting the position of the
loop handle.
■
INSTALLING HANGING BELT
1. Put the hook at the hanging belt in the D-ring at the
shoulder strap and adjust the length where it is easy
to work.
2. Carrying the unit on the back, put the other side of
the hook in the hanger plate.
(1) Shoulder strap
(2) Hook
(3) Hanger plate
(4) Loop handle
(2)
(2)
(3)
(4)
(1)
■
INSTALLING DEBRIS GUARD
WARNING
Do not use this machine without the debris guard.
Fit the top of the debris guard to the gear case, install
the debris guard on the main pipe with the accessory
clamp, and tighten the debris guard evenly with two
Phillips screws (M5xL30).
[Tightening torque]
1 to 2 N
•
m (10 to 20 kgf
•
cm)
(3)
(4)
(5)
(2)
(1)
(6)
(1) Gear case
(2) Clamp
(3) Phillips screw
(M5xL30)
(4) Main pipe
(5) Safety-guard
cover
(6) Fit this part to
the gear case.
■
MOUNTING THE CUTTING BLADE
WARNING
• Be sure to stop the engine before demounting
and remounting the cutting blade. Never try to
touch the blade while the engine is running.
• Always use Zenoah genuine cutting blades and
fittings for replacement.
• When demounting and remounting the cutting
blade, firmly secure the brush cutter and wear
heavy-duty gloves.
• The cutter blade rotates left (counterclockwise)
when viewed from the gear case. When the mount-
ing side of a cutting blade is predetermined, select
the mounting side correctly when mounting it.
Particularly, when a chip saw blade is mounted
reversely, the teeth may be chipped and fly away.
This is very dangerous.
• Be sure to clean the gear shaft thread complete-
ly before mounting the cutting blade. Dirt and
sand on the thread will cause loosening of the
blade mount. This is very dangerous.
• Never use a power impact driver or other high
torque tool or put all of your weight to fasten the
mounting bolt of the cutting blade. An excessive
tightening force will damage the mounting bolt or
the gear shaft and cause hazardous accident or
personal injury. Be sure to use the accompanying
socket wrench and tighten them firmly.
01-BKZ315L_GB_cs6＿二.indd 10
18/09/03 11:50
