MINiBOX 0-10V X3/X2/X1
Technical Support:
6
1.3
START-UP AND POWER LOSS
Depending on the configuration, some specific actions will be performed during the start-
up. For example, the integrator can set whether the output channels should switch to a
particular state and whether the device should send certain objects to the bus after the
power recovery. Please consult the next sections of this document for further details.
On the other hand, when a bus power failure takes place, the MINiBOX 0-10V devices
will interrupt any pending actions and will save its state so it can be recovered once the
power supply is restored. Also, after failure recovery, the analog outputs and fan coil
module will switch to the specific state configured in ETS (if any).