Daikin
Control
Module
–
Commercial
(SKY)
and
industrial
(VRV)
series
ZN1CL
–
KLIC
‐
DI
Technical
Note:
Installation
Note
© Zennio Avance y Tecnología S.L. Edition 2 For further information
www.zennio.com
Page.
2
of
3
On the other hand, for connecting the device KLIC-DI to the air-conditioning internal
unit, the terminal P1/P2 located in the PCB of the Daikin unit must be connected to
terminal P1/P2 located in one side of the KLIC-DI (this connector is included as
accessorize with the device).
If a Daikin wired control is included in the installation, the device KLIC-DI can be also
connected to the terminal P1/P2 of the wired control.
In order to locate the terminal P1/P2 in the PCB of the wired control, remove the
casing of the wired control and look for the terminals marked as P/P1 and N/P2.
CONNECTIONS DIAGRAMS
KLIC-DI (master, without Daikin wired control in the bus):
KLIC-DI (master/slave) + Daikin wired control (slave/master):
Leyend
Connection
Diagrams
A
KLIC
–
DI
B
Daikin
wired
control
C
Daikin
internal
unit
P1
‐
P2
Daikin
connection
bus
1
‐
2
Zennio’s
connection
terminal
*
The
wired
control
must
work
as
slave
when
KLIC
‐
DI
is
master
and
vice
versa
Once the device is powered from the KNX bus, the physical address and the corresponding application program
KLIC-DI can be downloaded.
Note
: Each KLIC-DI is
able to control
only one
internal unit.
It is not possible to
connect several internal
units in series and
control them with KLIC-
DI.
