INZennio
Z38i
INZennio
Z38i
–
Touch
Display
with
Ambient
Thermostat,
IR
receiver
and
Binary
Inputs.
ZN1VI
‐
TP38i
Technical
Documentation
© Zennio Avance y Tecnología S.L. Edition 1 Further information
www.zennio.com
Page
3
de
4
Technical
Documentation
Installation Figure (Read this completely before starting the installation):
1. The basic enclosure piece (the one including the display) must be placed into a standard
squared/rounded box (minimum diameter 65mm), as shown in figure below.
Inputs and BUS clamps must be previously connected.
2. Binary inputs screw Terminal-Clamp should be pre-wired to avoid re-installing the touch
panel.
3. Dismantling the display from the Basic enclosure piece invalidates the original warranty.
4. You are recommended to use a level tool to install the basic enclosure piece in the right
position by parking the points where the wall fixings will be inserted.
5. Once the wall fixings are inserted (unnecessary in wooden walls), the Basic enclosure piece
must be screwed with the right tightness to get a good fastening but avoiding any deformation
on the piece.
6. Remove the plastic foil protector (thin plastic film) from the display before installing the cover.
7. Install the cover by pressing on the four fixing points.
8. If uninstalling the device is mandatory, the cover would be dismantled by using a plain fork or
small knife, introducing these tools as much as possible between the cover and the Basic
enclosure, near the fixing points, to avoid any superficial damage to both pieces.
Extremely fragile
Display
Do not press on the
display during
installation as it might
cause its breakage
