© Zennio Avance y Tecnología S.L.
Edition 1
Further information
Page 4/4
SAFETY INSTRUCTIONS AND ADDITIONAL NOTES
•
Installation should only be performed by qualified professionals according to the laws and regulations applicable in each country.
•
Do not connect the mains voltage nor any other external voltage to any point of the KNX bus; it would represent a risk for th e entire
KNX system. The facility must have enough insulation between the mains (or auxiliary) voltage and the KNX bus or the wires of other
accessories, in case of being installed.
•
The facility must be equipped with a device that ensures the omnipolar sectioning. Installation of a 10A mini -circuit-breaker is
recommended. To prevent accidents, it must remain open in case of manipulation of the device.
•
The device has a short-circuit protection fuse that, in case of activation, should only be rearmed or replaced by the Zennio technical
service.
•
This device contains a security short-circuit proof transformer.
•
Once the device is installed (in the panel or box), it must not be accessible from outside.
•
For indoor use only
•
Keep the device away from water (condensation over the device included) and do not cover it with clothes, paper or any other material
while in use.
•
The WEEE logo means that this device contains electronic parts and it must be properly disposed of by following the instructions at
http://zennio.com/weee-regulation.
•
This device contains software subject to specific licences. For details, please refer to http://zennio.com/licenses.
INSTALLATION AND CONNECTION
•
This device must be exclusively installed in a 35mm DIN rail
inside a distribution box or an electrical panel.
•
Ensure suitable ventilation to prevent the temperature from
exceeding the permissible range.
•
Main power must be connected to L, N and ground
terminals.
•
The coil integrated bus output must be connected through a
standard KNX connector.
•
The additional output connection must be connected
according to the polarity indicated on the housing.
Attaching ALLinBOX 1612 v2 to DIN rail:
Removing ALLinBOX 1612 v2 from DIN rail:
Figure 3: Mounting ALLinBOX 1612 v2 on DIN rail
