English
Assembly and operating instructions
1. General information
1.1 Intended use
The Indoor T+H Sensor is used to measure and display room temperature
and relative humidity indoors. In addition, the recorded measured values
are sent via radio interface (wM-Bus or LoRaWAN®). The device is designed
for wall mounting. The sensor is used in the commercial and private housing
sector. Users are, for example, owners, residents and tenants of the premises
equipped with the sensor. Installation and commissioning can be carried out
by service companies of the housing industry or by the respective private
user. Operational safety is only guaranteed when used as intended according
to the manufacturer. No liability is accepted for damage caused by other
applications. Any modification is only permitted with the consent of the
manufacturer. Otherwise, the manufacturer´s declaration becomes invalid.
1.2
Safety instructions
■
Attention! The device is only intended for the designated use.
Attention! Improper use may result in damage to the device.
Caution! Improper opening of the device can lead to damage and possibly
injury to hands. Only use the tools listed in the instructions.
■
Caution! Unauthorized work on the device can no longer guarantee its
safety and functionality.
Caution! Loss of functionality and injuries may result from unauthorized
work on the device. Make sure of the required procedure in advance.
■
Caution! Make sure that the installation environment corresponds to the
specified operating range. Adhere to specified temperature and limit values
at all times.
■
Caution! To avoid damaging the device or impairing its functionality, chemi-
cal cleaning agents should not be used. If cleaning is necessary, use a dry or
slightly damp cloth.
■
Notice! The device is equipped with a permanently installed lithium battery
which must not be recharged. This type of battery is classified as dangerous
goods (Hazardous goods class 9). The applicable transport regulations
must be observed! Data sheets, safety data sheets and test reports of the
batteries are available on request. Please also note the following general
information on handling batteries.
■
Warning! The instrument contains a non-rechargeable lithium battery.
Attempting to recharge it will damage the device and possibly cause injury.
■
Attention! Under no circumstances may the device be disposed of in normal
household waste. Please observe our regulations for disposal
mentioned separately in this manual.
General information on handling lithium batteries or devices
with lithium batteries:
■
Caution! The following must be observed when handling lithium batteries
and devices with lithium batteries.
–
store protected from moisture
–
do not heat or throw into fire to avoid explosions
–
do not short-circuit
–
do not open or damage
–
do not recharge
–
do not store within reach of children
2. Product description
The indoor T+ H Sensor consists of a front part with sensor technology and LC
display and the corresponding back plate.
2.1 Intended use
The Indoor T+H Sensor measures temperature and relative humidity in
indoor spaces. The remote data transmission of the measurement data can
be done either by wireless M-Bus or LoRaWAN® radio technology (the radio
interface is configurable via the optical interface). The measurement of
the data takes place every three minutes. The radio transmission intervals
depend on the configured transmission scenario. The measured values are
displayed alternately on the LC display.
Typical use cases:
■
Supporting the user to optimize heating and ventilation behavior
■
Prevention of mold growth at critical points within the apartments
2.2 Scope of delivery
■
Indoor T+H Sensor incl. back plate
■
Fixing material (2 screws, 2 dowels & 1 plug-in seal)
■
Assembly instructions and declaration of conformity
2.3 Model variants
The sensor is currently offered and sold in the following variant:
■
Indoor T+H Sensor wM-Bus / LoRaWAN®
Indoor T+H Sensor
